WLED Frame Build
This is my second WLED frame build—and the smallest one I’ve created so far. Using resin 3D printing and leftover plywood scraps, I put together a compact 13" x 13" illuminated frame. The setup runs on a voltage regulator, an ESP32, and a rechargeable 11.1V lithium-ion battery. It takes about seven hours to fully charge, providing roughly six hours of continuous light. Prints of the original artwork are available in my store in two sizes. I’ve included a direct link below to Untitled #4, which is the name of this piece.
https://www.dartwork365.com/shop/p/zzj5uml2kyubcf2fm93dzszgxs8fnn
